This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Config option needed for "disable HDMI monitor detection and force connected status"
My QML application (no ui, does offscreen rendering) fails on start with "Segmentation fault", if no monitor attached. Runs fine if monitor is attached before app startup.
I need to be able to run QML application without monitor being connected to board. Currently getting "Segmentation fault", if no monitor attached. Works ok if monitor is attached.

I am looking for a way to disable HDMI monitor detection and force connected status, similar to Odroid XU4 settings, example
   # HDMI Hotplug Force (HPD)
   # 1 = Enables HOTPlug Detection
   # 0 = Disables HOTPlug Detection and force the connected status
   setenv hpd "0"

Any info is welcome.

My setup is QT 5.9.3. or 5.10 on Asus Tinker board with latest OS (Latest version v2.0.4 - Debian stretch based. 2017/11/15)


Forum Jump:

Users browsing this thread: 1 Guest(s)