This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Tinker Board Forum › Tinker Board / Tinker Board S › Software v
onshape.com

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
onshape.com
kenneth Offline
Junior Member
**
Posts: 17
Threads: 2
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Apr 2017
#1
04-07-2017, 11:56 AM
I was excited to find that Onshape 3d modeling software works on the TinkerOS v1.4. I have not tried v1.6 yet.

Onshape would hard crash on my RPI 3 and require a reboot.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)