This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
how do I enable LIRC?
#1
I have an IR sensor connected to the Tinker board.
It appears that lirc is not installed. I installed it using sudo apt-get install lirc

Im not sure that is or is not working properly. but I have no devices in /dev/lirc
to listen to. So i think this means it is not working.

how can I enable IR remote contol, and the devices of /dev/lirc ?

I have the sensor on GPIO pin 18, im not sure where to configure the GPIO for this driver.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)