This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pin Resetting to Normal
Hi, I am using tinkerboard for triggering low level relay module. For this using GPIO pin 7, Once i set pin to low after 3 to 4 second it's automatically resetting to some 1.44 to 1.55 voltage which causes turn off the relay because it's low level trigger relay. Is there any other way to use low level trigger relay with tinker board.
I use the GPIO to control an active low module. The relay are energized only after power on, because some is starting like that. After the correct setting they don't change any longer.
I currently use the gpio executable to control the GPIO output. Then the rest is controlled by home-assistant framework.
Light blue words might be a link. Have you try to click on them? Big Grin

Forum Jump:

Users browsing this thread: 1 Guest(s)