This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PoE Hat for Tinkerboard
Have been able to successfully use pisupply's PoE hat for Raspberrypi on tinkerboard.
Here is the link

This is a Power over ethernet add on board to power tinkerboard. The add on board works out of the box on tinkerboard as the GPIO configuration and PCB layout are identical to that of raspberry pi.
Quote:10-1300 mA output power

You may face issues here as the Tinkerboard will consume up to 2000mA...
Not a HAT, but I use these for PoE :

Active PoE Splitter Power Over Ethernet 48V to 5V 2.4A Micro USB Plug - £7.90

2.4A so plenty in the tank...
In addition to Mikerr's post, and you live in the US, this is available.

Edit: Use the correct PoE injector for your splitter. There are two different types (active and passive).
I disagree that 2.4A is "plenty", but it should work for many.

Ideally, you'd find something that delivers 5V on 2 pins and ground on 2 pins to the GPIO header.

I really hope that the Tinker Board II has a barrel connector for power.
I'm with BeauSlim. I would also like to see a barrel connector.

Some of my projects are using the GPIO pins (4 and 6) to supply power rather than that USB socket. Does anybody see a problem with that?

Forum Jump:

Users browsing this thread: 1 Guest(s)