This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Secondary screen ( HDMI <-> DSI )
#1
Information 
Hi all, 

Today I was try to adding secondary screen (hdmi) and couldnt figure out why hdmi was visible in terminal but not on "Preferences>Monitor Settings". However I figured out and in case if you going to use secondary screen on TB use following steps;

# list all the available output resolution
$ xrandr

most probably you will have DSI-1 as primary and HDMI-1 is disconnected. 

# activate hdmi over dsi
$ xrandr --output HDMI-1 --auto --right-of DSI-1 (make sure the device name is the same as listed in "xrandr" command)

# Change resolution of HDMI
$ xrandr --output HDMI-1 --mode 1920x1080

After this commands, the same settings will be visible on "Preferences>Monitor Settings" 

Some other useful commands can be helpful on wiki but they havent mentioned for secondary screen.

Hope this helps  Rolleyes
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)